Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
en:netzer:roadmap [2014/01/07 20:37] svesch Latest state |
en:netzer:roadmap [2014/02/09 14:32] 127.0.0.1 external edit |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Roadmap ====== | ||
| + | |||
| + | ===== Software Version 1.5 ===== | ||
| + | |||
| + | ==== Network protocols ==== | ||
| + | |||
| + | * DNS Client (manual configurable or via DHCP) - Done | ||
| + | * SNTP Client (manual configurable via IP or network name - name resolve via DNS is needed). Display current time on the index page - Done | ||
| + | |||
| + | |||
| + | ==== Process image ==== | ||
| + | |||
| + | * Map all states of the Netzer into a process image - Done. | ||
| + | * Direct mapping of process image members (i.e. interconnection of pins). | ||
| + | * Process image is accessible via HTTP | ||
| + | * ModbusTCP server implementation | ||
| + | |||
| + | |||
| + | ==== GPIO ==== | ||
| + | |||
| + | * Activation of pins if a client is connected to GPIO or serial server (also inverted) -> Is also done with the process image implementation. | ||
| + | * Changeable GPIO names | ||
| + | * Configure state of GPIO pin in power down mode - Done with process image | ||
| + | |||
| + | |||
| + | ==== I2C ==== | ||
| + | |||
| + | * Configuration of an INT pin (one of the GPIOs) - Done with process image | ||
| + | * Extending the procotol for reading out this INT pin - Done with process image | ||
| + | * Further mode, where Netzer acts as I2C monitor and sniffes the I2C traffic and transfers it to the network (Done). | ||
| + | |||
| + | |||
| + | ==== Serial Interface ==== | ||
| + | |||
| + | * Configurable parity bit (done). | ||
| + | * Handshake (done). | ||
| + | |||
| + | |||
| + | ==== Else ==== | ||
| + | |||
| + | * Integration of the PIC watchdog. | ||
| + | * Show the time since Netzer has been active (done) | ||
| + | |||
| + | |||
| + | ===== Hardware ===== | ||
| + | |||
| + | ==== Extension boards for the breakout board ==== | ||
| + | |||
| + | * **LCD board** with Display (text or graphical), SD card, SRAM, EEPROM and Buzzer already under development | ||
| + | * **Dimmer board** with two channel Triac dimmer, almost ready to run. | ||
| + | * **Domestic board** with Relais, Triac dimmer, temperature and light sensor and 1-Wire-interface is also under development. | ||
| + | * Interface board with RS485 and RS232 (complete) - not yet started. | ||
| + | |||
| + | |||
| + | |||
| + | ===== Netzer 2:0 ===== | ||
| + | |||
| + | More of all! :) Not before end of 2014. | ||
| + | |||
| + | |||
