Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
en:netzer:io [2014/08/17 16:46] svesch [Impulse output] |
en:netzer:io [2014/09/28 09:28] svesch [Input capture (since version 1.6)] |
||
---|---|---|---|
Line 169: | Line 169: | ||
The capture (second) edge can be configured as falling or rising one. | The capture (second) edge can be configured as falling or rising one. | ||
The trigger edge depends on the common impulse mode parameter (see below). | The trigger edge depends on the common impulse mode parameter (see below). | ||
- | |||
- | The calibration offset shall be used to compensate interrupt latency time and clock errors. | ||
- | The value is added to each measured value automatically. | ||
On Netzer startup or after configuring for capture mode the measured value is set to 0. | On Netzer startup or after configuring for capture mode the measured value is set to 0. |