====== Roadmap ======

===== Next software Version 1.7 =====

==== Network protocols ====

  * SNTP Client (manual configurable via IP or network name - name resolve via DNS is needed). Display current time on the index page - Partly implemented


==== Process image ====

  * [[process|Process module]]
  * Map all states of the Netzer into a process image - Done.
  * Direct mapping of process image members (i.e. interconnection of pins).
  * Process image is accessible via HTTP
  * ModbusTCP server implementation 


==== GPIO ====

  * Activation of pins if a client is connected to GPIO or serial server (also inverted) -> Is also done with the process image implementation.
  * Changeable GPIO names
  * Configure state of GPIO pin in power down mode - Done with process image


==== I2C ====

  * Configuration of an INT pin (one of the GPIOs) - Done with process image
  * Extending the procotol for reading out this INT pin - Done with process image
  * Further mode, where Netzer acts as I2C monitor and sniffes the I2C traffic and transfers it to the network (Done).


==== Serial Interface ==== 

  * Configurable parity bit (done).
  * Handshake (done).


==== Else ====

  * Integration of the PIC watchdog.
  * Show the time since Netzer has been active (done)
  * Implement some python GUI programs for accessing Netzer
  * [[websockets|WebSocket]]
  * [[actioncgi|CGI]]
  * [[commandserver|JSON command server]]


===== Hardware =====

==== Extension boards for the breakout board ====

  * **LCD board** with Display (text or graphical), SD card, SRAM, EEPROM and Buzzer already under development
  * **Dimmer board** with two channel Triac dimmer, almost ready to run.
  * **Domestic board** with Relais, Triac dimmer, temperature and light sensor and 1-Wire-interface is also under development.
  * Interface board with RS485 and RS232 (complete) - not yet started.



===== Netzer 2:0 =====

More of all! :) Not before end of 2015.