News from the Netzer (netwerker or networker if you like :) world
2011-11-19 The project Wiki is online!
This project websites are no longer maintained!
Please use the Wiki from now and change your bookmarks!
2011-10-21 Release 1.4 base version is online!
The "Pro" version will be available in a few days.
2011-10-18 Netzer mailing list start up
Since last week there is a news group online for discussing problems and suggestions regarding Netzer. More infos you can find here.
2011-07-01 Networker Breakout Board ready to run
2011-04-25 Bugfix III
Problem with resetting the serial parameters to factory settings fixed. Also a very bad bug was fixed which leads to a completly broken SPI (master and slave) interface. Thanks goes to Cyrille Hasdenteufel for the bug report. Download the update here.
2011-04-13 Next Bugfix Release
Values to place holder 'x' of the GPIO server were completly wrong interpreted. Download the update here. Thanks goes to Norbert Kollek for the bug report.
2011-03-15 Bugfix Release
- Wrong setting in the Netzer oscillator generates completly wrong frequencies on all serial interfaces.
- Problems while obtaining the IP address via DHCP at some DHCP servers.
2011-02-28 New Netzer arrived
Here we go to the loading platform.
2011-02-22 Release 1.3
Most important new feature is the authorization module. Only authorized user can access the Netzer websites. Also there some bugfixes and small enhancements (see the release notes). The hexfile can be downloaded from here.
Please consider the notes about authorization in the users corner.
2011-01-31 Problems with firmware updates on the Elektor Netzer
The second charge of the Elektor Netzers (=Networker) were flashed with incorrect firmware.
Firmware updates are not possible!
Get a solution in the FAQ rubric.
2011-01-08 Release 1.2 online
This Release supports the I2C bus. Netzer acts as I2C Master, slave accesses like Read, Write and Write/Read are supported. The clock rates 100 kHz and 400 kHz can be set via the Netzer web interface.
Thanks goes to Hygrosens Instruments GmbH for the friendly implementation support.
2011-01-07 Netzer as Eagle library!
On the hardware pages the ready to use Eagle library for download is available.
December 2010 Netzer in Elektor!
The articel discusses the base functionality of Netzer. Here is the link to the project: Link
2010-11-02 Version 1.1 Released
The base functionality (GPIO, UART, SPI Master, SPI Slave) are completly implemented. Just in time for the Elektor articel...